Power Beam-ac (Ubiquiti)

Reset Button:-

 

To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the PowerBeam is already powered on. Alternatively, the PowerBeam may be reset remotely via a Reset button located on the bottom of the Gigabit PoE adapter.

 

Release Button

After you assemble the PowerBeam, check the Release button; it should be fully engaged in the Release Button Slot of the Rear Housing. This ensures that the Antenna Feed is locked into place. If you need to remove the Antenna Feed, you must depress the Release button first.

 

LED Signal

In airOS, you can modify the wireless signal strength threshold values for each LED on the Advanced tab under Signal LED Thresholds. The default values are shown below:

  

• LED will light blue when the wireless signal strength is above -65 dBm. 
• LED will light blue when the wireless signal strength is above -73 dBm. 
• LED will light blue when the wireless signal strength is above -80 dBm. 
• LED will light blue when the wireless signal strength is above -94 dBm. 
• The Ethernet LED will light steady blue when an active Ethernet connection is made and flash when there is activity. 
• The Power LED will light blue when the device is connected to a power source.